EMAIL TO A FRIEND PRINT ARTICLE

ADDITIONAL INFO
	Materials Three sheets of 6mm or 1/4-inch-thick marine- or exterior-grade plywood (from Home Depot) Two gallons of 105 epoxy resin with 205 hardener and 16 ounces of 405 filleting blend filler (from Gougeon/ West System, 517-684-7286) Sixty feet of four-inch-wide fiberglass tape Six ounces of 423 graphite (for mixing with epoxy to form undercoating; from Gougeon/West System) Total cost: $200 to $300 Tools Jigsaw Block plane Round putty knife Drill (1/8-inch bit) Furniture scraper Paint brushes Wire or plastic ties

RELATED ARTICLES
	•DIY: Adirondack Chairs •D-I-Y Treehouse •Build Your Own Tool Shed •Quick and Easy Oars •Flooring for Fido •Port-A-Cabin •Boot Bench •Build a 3-D Course

Build Your Own Duck Boat

By Paul Butler

Apr 1, 2003

4. Setting the Keel
Cut out and seal a plywood keel with two coats of epoxy; drill a hole two inches in diameter in the aft end of the keel for a tie-down when cartopping the boat and also for a tether loop when dragging the hull (see first diagram). Install the keel to the centerline of the hull bottom by applying beads of thickened epoxy to both sides of the keel and smoothing them into fillets.

NEXT
Page 1 | Page 2 | Page 3 | Page 4 | Page 5

Search within the D-I-Y Projects archives

[Browse D-I-Y Projects archives] - [Advanced Search]

Comment on This Article At 8:44 AM, 2008-11-12, Peter Hutt said: could use some diagrams and measurements. other than that,it's a great design. will give it a try when I can find the time. Flag this comment as offensive At 8:47 PM, 2008-10-15, don said: Are these plans free? Flag this comment as offensive At 12:00 AM, 2008-10-28, Ron Schwartz said: The instructions are great, but the article is missing the most important part. That is the diagram showing all the pieces and their measurements. Flag this comment as offensive Your Name: Enter the following word: Your Comments: Please keep comments focused on the subject (and profanity-free) or we may delete your post. Do not enter more than 10 lines. If you see inappropriate language, e-mail us.

We require all participants in interactive areas to accept the terms of the Bonnier Corporation subscriber agreement. Please read the agreement before making comments. When you click on the button above to submit your comments, you are indicating your acceptance of and are agreeing to adhere to the terms of the subscriber agreement.